[ANCP] Layer 2 Parameters in the Protocol document

[Menachem.Dodge at ecitele.com]

Hi,

        I
sent this email over a week ago and have had no response. I would appreciate
a reply on how the protocol handles: Multiple Vlans on a 
single encapsulation and also multiple
encapsulations.


        Thank
You Kindly.

        Best
Regards,
        Menachem
Dodge

========================================================================

Original Email:



        Regarding
the document: "draft-wadhwa-gsmp-l2control-configuration" and
following the questions I raised at the meeting in Montreal,
 I would like to request an explanation
of how to handle:

        1.
 Multiple Vlans in a single encapsulation.
        2.
 Multiple Vlans and Multiple encapsulations.



        1.
Multiple Vlans in a single encapsulation.

         
       a. Should an Access-Loop-Circuit-Id
be defined for each Vlan which means that this is a many-to-one relationship?
         
       b. Should there be more than one Access-Loop-Remote-Id's
or is one sufficient? If more are needed, how are they associated with
an
         
           Access-Loop-Circuit-Id?
         
       c. Should there be an Access-Aggregation-Circuit-Id-Binary
and Access-Aggregation-Circuit-Id-ASCII for each 
 Access-Loop-Circuit-Id defined?
         
               d. I assume there
are only one set of "DSL Line Attributes" defined which are common
to the physical line.

           
   2. Multiple Vlans and Multiple encapsulations. 
         
      a.  If the Vlan's are related to different
"Access Loop Encapsulations" how is this association between
Vlan and encapsulation shown?
        

Best Regards,
Menachem
_______________________________________________
ANCP mailing list
ANCP at ietf.org
https://www1.ietf.org/mailman/listinfo/ancp