[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
FW: [ANCP] Layer 2 Parameters in the Protocol document
Hi Sanjay, draft-authors,
the list appears to have a number of outstanding
questions like the one below. Could you please look into addressing
these?
Regards,
Woj.
Hi,
I have a question regarding the "Access-Loop-Circuit-ID" as
defined in the document "draft-wadhwa-gsmp-l2control-configuration-01.txt".
In the case of an Ethernet
based local loop the format is defined as:
"Access-Node-Identifier eth
slot/port[:vlan-id]" meaning that the vlan-id is optional.
In the case of an ATM based
local loop the format is defined as:
"Access-Node-Identifier atm
slot/port:vpi.vci" meaning that the vpi.vci is mandatory.
I would like
this changed to "Access-Node-Identifier atm slot/port[:vpi.vci]" meaning that
the vpi.vci is optional.
This would allow for multiple vpi/vci(s) on the same port
as a message could be sent without the vpi.vci field.
===========================================================================
I have a similar question regarding the
"Access-Aggregation-Circuit-ID-ASCII" as defined in the document
"draft-wadhwa-gsmp-l2control-configuration-01.txt".
In the case of an Ethernet
based local loop the format is defined as:
"Access-Node-Identifier eth
slot/port[:inner-vlan-id][:outer-vlan-id]" meaning that the vlan-ids are
optional.
In the case of an ATM based local loop the format is defined as:
"Access-Node-Identifier atm slot/port:vpi.vci" meaning that the vpi.vci is
mandatory.
I would like this changed to "Access-Node-Identifier atm
slot/port[:vpi.vci]" meaning that the vpi.vci is optional.
Thank you kindly.
Best Regards,
Menachem
_______________________________________________
ANCP mailing list
ANCP at ietf.org
https://www1.ietf.org/mailman/listinfo/ancp
_______________________________________________
ANCP mailing list
ANCP at ietf.org
https://www1.ietf.org/mailman/listinfo/ancp