[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [dcp] rcp-response packet reserved bits

To: "Patrick R. McManus" <mcmanus@ducksong.com>
Subject: Re: [dcp] rcp-response packet reserved bits
From: Eddie Kohler <kohler@icir.org>
Date: Sat, 04 May 2002 10:19:38 -0700
cc: dcp@ietf.org
In-Reply-To: Message from "Patrick R. McManus" <mcmanus@ducksong.com> of "Sat, 04 May 2002 13:11:04 EDT." <20020504171104.GA1264@ducksong.com>
List-Id: Datagram Control Protocol <dcp.ietf.org>
Sender: dcp-admin@ietf.org

Hi Patrick,

Thanks for pointing this out. I think all 0's are required at this stage.

Eddie

> 4.6 defines the DCP-Response packet format. The diagram lists 8
> reserved bits after the generic header, assumably for alignment
> purposes when combined with the 24 bit ack header.
> 
> However, it doesn't list a required value for the reserved field.

_______________________________________________
dcp mailing list
dcp@ietf.org
https://www1.ietf.org/mailman/listinfo/dcp

References:
- [dcp] rcp-response packet reserved bits
  - From: "Patrick R. McManus" <mcmanus@ducksong.com>

Prev by Date: Re: [dcp] DCP comment: Support for IPv6
Next by Date: Re: [dcp] DCP comment: Support for IPv6
Previous by thread: [dcp] rcp-response packet reserved bits
Next by thread: [dcp] sequence numbers on resend
Index(es):
- Date
- Thread