![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
Hi Spencer
thanks for the quick reply
Regards, marcelo
El 23/12/2007, a las 1:24, Spencer Dawkins escribió:
Hi, Marcelo,
I think we're good on everything except one semi-nit - and I'm good on the DAD text I questioned, because I didn't have the context about not performing DAD as a DoS mitigation (just to be explicit about that).
In the remaining text below, I think I was actually asking "who verifies" - if it's the receiver, I might suggest s/we may need to verify/the receiver may need to verify/, etc.
Thanks, and thanks for a quick reply (while I could remember writing the review!)
Spencer
----- Original Message ----- From: "marcelo bagnulo braun" <marcelo at it.uc3m.es>
To: "Spencer Dawkins" <spencer at mcsr-labs.org>
Cc: "Kurt Lindqvist" <kurtis at kurtis.pp.se>; "Geoff Huston" <gih at apnic.net>; "Jari Arkko" <jari.arkko at piuha.net>; <ietf at ietf.org>; "General Area Review Team" <gen-art at ietf.org>
Sent: Saturday, December 22, 2007 12:53 PM
Subject: Re: Gen-ART Last Call review of draft-ietf-shim6-hba-04
Hi Spencer,
thanks for the review
see comments below...
El 24/11/2007, a las 3:59, Spencer Dawkins escribió:
For multihoming applications, it is also relevant to verify if a
given HBA address belongs to a certain HBA set. An HBA set is
identified by a CGA Parameter Data structure that contains a Multi-
Prefix Extension. So, it is then needed to verify if an HBA belongs
Spencer: "needed to verify" appears twice in two sentences, and I don't understand what it means. I'm guessing this is saying something like "needed to verify", but I'm really in the weeds here (I'm not sure who is doing the verification, either - I can guess, but I can't figure that out from the text)
ok, i have changes it is needed to verify bu we need to verify, resulting in the following text:
For multihoming applications, it is also relevant to verify if a given HBA address belongs to a certain HBA set. An HBA set is identified by a CGA Parameter Data structure that contains a Multi- Prefix Extension. So, we need to verify if a given HBA belongs to the HBA set defined by a CGA Parameter Data Structure. It should be noted that we may need to verify if an HBA belongs to the HBA set defined by the CGA Parameter Data Structure of another HBA of the set
_______________________________________________ Ietf mailing list Ietf at ietf.org https://www1.ietf.org/mailman/listinfo/ietf
_______________________________________________ Ietf mailing list Ietf at ietf.org https://www1.ietf.org/mailman/listinfo/ietf
Note Well: Messages sent to this mailing list are the opinions of the senders and do not imply endorsement by the IETF.