[ipcdn] DEFVAL for pktcSigDevVmwiMode in draft--09

There seems to be the following issue which draft's authors might want to also consider in the course of ongoing draft's review.

The default value for pktcSigDevVmwiMode MIB Object currently defines "dtAsETS" as the default alerting method. On the other hand, the default value for the pktcSigDevCIDMode MIB Object currently defines the "rpAsETS" as the default method for CallerID.

As Caller ID and VMWI functionality, in most cases, are embodied into a single device, and no country, in practice, uses different alerting methods for the two at the same time, it does not make much sense to require two different alerting methods as the default values for Caller ID and VMWI.

As a matter of fact, there are very few countries that deploy "dtas" alerting for VMWI (Denmark, Brazil) but they, anyway, require "dtmf" signaling protocol, rather than the "fsk" one currently defined as the default signaling method in draft-09.

To improve the consistency of the MIB and convenience for Operators in the field, the following is proposed: the default value of pktcSigDevVmwiMode MIB Object should be "rpAsETS", rather than "dtAsETS":

pktcSigDevVmwiMode OBJECT-TYPE

SYNTAX INTEGER {

.....................................

DEFVAL { rpAsETS }

::= {pktcSigDevConfigObjects 27 }

Regards,

Eugene.

_______________________________________________ IPCDN mailing list IPCDN at ietf.org https://www1.ietf.org/mailman/listinfo/ipcdn