[rfc2461bis] Clarify the use of the M and O flags

["Soliman Hesham" <H.Soliman at flarion.com>]

As far as 2461bis is concerned it is stated in the 
current draft that setting the M flag implies that
DHCPv6 is used for address config. If the O flag
is set, the draft refers to DHCPv6 for other config
parameters. RFC 3315 is also referenced. 

Please see section 4.2, definition of the M and O
flags. If there are no further comments I'll close
this issue.

Hesham

===========================================================
This email may contain confidential and privileged material for the sole use
 of the intended recipient.  Any review or distribution by others is strictly
 prohibited.  If you are not the intended recipient please contact the sender
 and delete all copies.
===========================================================


--------------------------------------------------------------------
IETF IPv6 working group mailing list
ipv6 at ietf.org
Administrative Requests: https://www1.ietf.org/mailman/listinfo/ipv6
--------------------------------------------------------------------