Route Targets from CE

["Sakthivadivu.S.S" <sakthivss@future.futsoft.com>]

Hi,

   Section 4.3.1 of BGP/MPLS 2547.draft says that

  " If the PE and the CE are themselves BGP peers (see section 7), then
   the SP may allow the customer, within limits, to specify how its
   routes are to be distributed.  The SP and the customer would need to
   agree in advance on the set of RTs which are allowed to be attached
   to the customer's VPN routes.  The CE could then attach one or more
   of those RTs to each IP route which it distributes to the PE.  This
   gives the customer the freedom to specify in real time, within agreed
   upon limits, its route distribution policies.  If the CE is allowed
   to attach RTs to its routes, the PE MUST filter out all routes which
   contain RTs that the customer is not allowed to use.  If the CE is
   not allowed to attach RTs to its routes, but does so anyway, the PE
   MUST remove the RT before converting the customer's route to a VPN-
   IPv4 route. "


   Can you please temm me how can SP and customer agrree for some Route
Target's.?

   Is there any configuration of Route targets in PE and CE for this.?

Regards,
Sakthi










***************************************************************************
This message is proprietary to Future Software Limited (FSL)
and is intended solely for the use of the individual to whom it
is addressed. It may contain  privileged or confidential information
and should not be circulated or used for any purpose other than for
what it is intended.

If you have received this message in error, please notify the
originator immediately. If you are not the intended recipient,
you are notified that you are strictly prohibited from using,
copying, altering, or disclosing the contents of this message.
FSL accepts no responsibility for loss or damage arising from
the use of the information transmitted by this email including
damage from virus.
***************************************************************************