Re: [MEXT] Bulk Binding Refresh or Deregistration after Separate Binding Registration in MCoA

["Desire Oulai" <desire.oulai at ericsson.com>]

Hi Benjamin,

 If initial bindings are done by separate registration, we can assume
that CoA verification is done as each BU as the corresponding CoA as
source address. Therefore, the MN can perform bulk re-registration or
deregistration. Ruyji, should we have some text related to this in the
draft?

BR

Desire

> -----Original Message-----
> From: Benjamin Lim [mailto:benjamin.limck at sg.panasonic.com] 
> Sent: December 18, 2008 1:52 AM
> To: Ryuji Wakikawa
> Cc: Desire Oulai; mext at ietf.org
> Subject: Re: [MEXT] Bulk Binding Refresh or Deregistration 
> after Separate Binding Registration in MCoA
> 
> Hi Ryuji,
> 
> Ryuji Wakikawa wrote:
> >> However, is it possible for a MN to do separate binding 
> registration 
> >> then do bulk binding refresh or bulk deregistration?
> > 
> > Yes, MN can switch to bulk registration after the separate 
> registration.
> [Ben] So does the HA accept this bulk registration BU from 
> the MN based on the fact that MN has previously done separate 
> binding registration?
> Or does it do some form of CoA verification?
> 
> Regards,
> Benjamin Lim
> 
> > 
> > regards,
> > ryuji
> > 
> > 
> >>
> >>
> >> BR
> >>
> >> Desire
> > 
> > _______________________________________________
> > MEXT mailing list
> > MEXT at ietf.org
> > https://www.ietf.org/mailman/listinfo/mext
> > 
> > 
> 
> 
> 
_______________________________________________
MEXT mailing list
MEXT at ietf.org
https://www.ietf.org/mailman/listinfo/mext