| Shahram -
6.8 and 10 clearly state that the rules of 6.8.3 apply. I don't believe there is a need for more verbiage than exists.
6.8.12 is discussing a different attribute, the detect multiplier. It clearly states that a poll sequence is not necessary. This should be obvious as the detectmult is a local matter and doesn't affect anything on the remote end.
You do need to use the poll sequence in all cases. Demand mode setting is orthogonal.
-DWard On Aug 18, 2009, at 9:30 PM, Shahram Davari wrote: Hi, There is a discrepancy in the base draft regarding when any of the BFD parameter changes. Section 6.8.10, 11 and 12 say that poll sequence is not required when bfd.DesiredMinTxInterval or bfd.RequiredMinRxInterval are changed, while section 6.8.3 says: " If either bfd.DesiredMinTxInterval is changed or bfd.RequiredMinRxInterval is changed, a Poll Sequence MUST be initiated (see section 6.5)" Which one is correct? If not in demand mode is there any need to initiate Poll if any of the local parameters change? Thanks, Shahram |
