Behave WG T. Savolainen Internet-Draft Nokia Intended status: Standards Track J. Korhonen Expires: January 11, 2012 Nokia Siemens Networks July 10, 2011 Discovery of a Network-Specific NAT64 Prefix using a Well-Known Name draft-ietf-behave-nat64-discovery-heuristic-02.txt Abstract This document describes a method for detecting presence of DNS64 and for learning IPv6 prefix used for protocol translation on an access network without explicit support from the access network. The method depends on existence of a known IPv4-only domain name. The information learned enables applications and hosts to perform local IPv6 address synthesis and on dual-stack accesses avoid traversal through NAT64. Status of this Memo This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79. Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet- Drafts is at http://datatracker.ietf.org/drafts/current/. Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress." This Internet-Draft will expire on January 11, 2012. Copyright Notice Copyright (c) 2011 IETF Trust and the persons identified as the document authors. All rights reserved. This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (http://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must Savolainen & Korhonen Expires January 11, 2012 [Page 1] Internet-Draft NSP Discovery using WKN July 2011 include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License. Table of Contents 1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . 3 2. Requirements and Terminology . . . . . . . . . . . . . . . . . 3 2.1. Requirements . . . . . . . . . . . . . . . . . . . . . . . 3 2.2. Terminology . . . . . . . . . . . . . . . . . . . . . . . . 4 3. Host behavior . . . . . . . . . . . . . . . . . . . . . . . . . 4 3.1. Connectivity test . . . . . . . . . . . . . . . . . . . . . 5 4. Considerations for hosting the IPv4-only well-known name . . . 6 5. DNS(64) entity considerations . . . . . . . . . . . . . . . . . 6 6. Exit strategy . . . . . . . . . . . . . . . . . . . . . . . . . 6 7. Security Considerations . . . . . . . . . . . . . . . . . . . . 6 8. IANA Considerations . . . . . . . . . . . . . . . . . . . . . . 6 8.1. About IPv4 address for the well-known name . . . . . . . . 7 9. Acknowledgements . . . . . . . . . . . . . . . . . . . . . . . 7 10. Normative References . . . . . . . . . . . . . . . . . . . . . 7 Authors' Addresses . . . . . . . . . . . . . . . . . . . . . . . . 8 Savolainen & Korhonen Expires January 11, 2012 [Page 2] Internet-Draft NSP Discovery using WKN July 2011 1. Introduction As part of the transition to IPv6 NAT64 [RFC6146] and DNS64 [RFC6147] technologies will be utilized by some access networks to provide IPv4 connectivity for IPv6-only hosts. The DNS64 utilizes IPv6 address synthesis to create local IPv6 presentations of peers having only IPv4 addresses, hence allowing DNS-using IPv6-only hosts to communicate with IPv4-only peers. However, DNS64 cannot serve applications not using DNS, such as those receiving IPv4 address literals as referrals. Such applications could nevertheless be able to work through NAT64, provided they are able to create locally valid IPv6 presentations of peers' IPv4 addresses. Additionally, DNS64 is not able to do IPv6 address synthesis for hosts running validating DNSSEC enabled resolvers, but instead the synthetization must be done by the hosts. In order to perform IPv6 synthesis hosts have to learn the IPv6 prefix(es) used on the access network for protocol translation. This document describes a best effort method for advanced applications and hosts to learn the information required to perform local IPv6 address synthesis. An example application is a browser encountering an IPv4 address literal in an IPv6-only access network. Another example is a host running validating security aware DNS resolver. The knowledge of IPv6 address synthetization taking place may also be useful if DNS64 and NAT64 are present in dual-stack enabled access network. In such cases hosts may choose to prefer IPv4 in order to avoid traversal through protocol translators. The described method is intented for the scenarios where network assisted NAT64 and prefix discovery solutions are not available. 2. Requirements and Terminology 2.1. Requirements The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in [RFC2119]. Savolainen & Korhonen Expires January 11, 2012 [Page 3] Internet-Draft NSP Discovery using WKN July 2011 2.2. Terminology Well-Known IPv4-only Name: a fully qualified domain name well-known to have only A record. Well-Known IPv4 Address: an IPv4 address that is well-known and mapped to the well-known name. 3. Host behavior A host requiring information about presence of NAT64 and the IPv6 prefix used for protocol translation shall send a DNS query for AAAA records of a known IPv4-only fully qualified domain name. This may happen, for example, at the moment the host is configured an IPv6 address of a DNS server. This may also happen at the time when first DNS query for AAAA record is initiated. The host may perform this check in both IPv6-only and dual-stack access networks. When sending AAAA query for the known name a host MUST set "Checking Disabled (CD)" bit to zero, as otherwise the DNS64 will not perform IPv6 address synthesis hence does not reveal the IPv6 prefix(es) used for protocol translation. A DNS reply with one or more non-empty AAAA records indicates that the access network is utilizing IPv6 address synthesis. A host MUST look through all of the received AAAA records to collect all available prefixes. The prefixes may include Well-Known Prefix or one or more Network-Specific Prefixes. In the case of NSPs the host SHALL search for the IPv4 address inside of the received IPv6 addresses to determine used address format. An IPv4 address inside synthesized IPv6 address should be found at some of the locations described in [RFC6052]. If the searched IPv4 address is not found on any of the standard locations the network must be using different formatting. Developers may over time learn on IPv6 translated address formats that are extensions or alternatives to the standard formats. Developers MAY at that point add additional steps to the described discovery procedures. The additional steps are outside the scope of the present document. The host should ensure a 32-bit IPv4 address value is present only once in an IPv6 address. In case another instance of the value is found inside the IPv6, the host shall repeat the search with another IPv4 address, if possible. In the case only one IPv6 prefix was present in the DNS response: a host shall use that IPv6 prefix for both local synthetization and for Savolainen & Korhonen Expires January 11, 2012 [Page 4] Internet-Draft NSP Discovery using WKN July 2011 detecting synthesis done by the DNS64 entity on the network. In the case multiple IPv6 prefixes were present in the DNS response: a host SHOULD use all received prefixes when determining whether other received IPv6 addresses are synthetic. However, for selecting prefix for the local IPv6 address synthesis host MUST use the following prioritization order, of which purpose is to avoid use of prefixes containing suffixes reserved for the future [RFC6052]: 1. Use NSP having /96 prefix 2. Use WKP prefix 3. Use longest available NSP prefix In the case of NXDOMAIN or empty AAAA reply: the DNS64 is not available on the access network, network filtered the well-known query on purpose, or something went wrong in the DNS resolution. All unsuccesful cases result in unavailability of a host to perform local IPv6 address synthesis. The host MAY periodically resend AAAA query to check if DNS64 has become available or temporary problem cleared. The host MAY perform A query for the well-known name to learn whether the service is available at all (see section 6 about Exit Strategy). The host MAY also continue monitoring DNS replies with IPv6 addresses constructed from WKP, in which case the host MAY use the WKP as if it were learned during the query for well-known name. To save Internet's resources, if possible, a host should perform NAT64 discovery only when needed (e.g. when local synthesis is required, cached reply timeouts, new network interface is started, and so forth. Furthermore, the host SHOULD cache the replies it receives and honor TTLs. 3.1. Connectivity test After the host has obtained a candidate prefix and format for the IPv6 address synthesis it may locally synthesize an IPv6 address, by using a publicly routable IPv4 address, and test connectivity with the resulting IPv6 address. The connectivity test may be conducted e.g. with ICMPv6 or with a transport layer protocol. This connectivity test ensures local address synthetization results in functional and protocol translatable IPv6 addresses. The host MUST NOT perform connectivity test for the well-known IPv4 address of the well-known name, but instead to some other destination such as host vendor servers. Savolainen & Korhonen Expires January 11, 2012 [Page 5] Internet-Draft NSP Discovery using WKN July 2011 4. Considerations for hosting the IPv4-only well-known name The authoritative nameserver for the well-known name shall have DNS record TTL set to a long value in order to improve effectiveness of DNS caching. The exact value depends on availability time for the used public IPv4 address, but should not be longer than one year. 5. DNS(64) entity considerations DNS(64) servers MUST NOT interfere or perform special procedures for the queries related to the well-known name until the time has arrived for the exit strategy to be deployed. 6. Exit strategy A day will come when this tool is no longer needed or is replaced by some other tool. In global scope the exit strategy includes sending NXDOMAIN replies by the authoritative nameserver of the well-known name with very long TTL. In local scope, after network administrators have determined there is no longer need for this tool in their network, they may start locally serving A and AAAA queries for the well-known name with NXDOMAIN reply. A client implementation receiving NXDOMAIN for the AAAA query for the well-known name is either not talking to DNS64 or this tool has been disabled. NXDOMAIN response also for the A query for the well-known name means this tool has been disabled. 7. Security Considerations No security considerations have been identified. 8. IANA Considerations A well-known name should be defined and a public IPv4 address allocated (by IANA? IETF? Someone else?). Savolainen & Korhonen Expires January 11, 2012 [Page 6] Internet-Draft NSP Discovery using WKN July 2011 8.1. About IPv4 address for the well-known name The global IPv4 address for the well-known, if possible, should be chosen so that it is unlikely to appear more than once within an IPv6 address and also as easy as possible to find from within the synthetic IPv6 address. A global address is required as otherwise DNS64 entity will not perform AAAA record synthesis. The address does not have to be routable as no communications are initiated to the IPv4 address. Allocating two IPv4 addresses would improve the heuristics in cases where the primary IPv4 address' bit pattern appears more than once in the synthetic IPv6 address (NSP prefix contains the same bit pattern as the IPv4 address). If no well-known IPv4 address is allocated for this method, the heuristic requires sending additional A query to learn the IPv4 address that is sought inside the received IPv6 address. Without knowing IPv4 address it is impossible to determine address format used by DNS64. 9. Acknowledgements Authors would like to thank Andrew Sullivan, Dan Wing, Washam Fan, Cameron Byrne, Zhenqiang Li, and Christian Huitema for significant improvement ideas and comments. 10. Normative References [RFC2119] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, March 1997. [RFC6052] Bao, C., Huitema, C., Bagnulo, M., Boucadair, M., and X. Li, "IPv6 Addressing of IPv4/IPv6 Translators", RFC 6052, October 2010. [RFC6146] Bagnulo, M., Matthews, P., and I. van Beijnum, "Stateful NAT64: Network Address and Protocol Translation from IPv6 Clients to IPv4 Servers", RFC 6146, April 2011. [RFC6147] Bagnulo, M., Sullivan, A., Matthews, P., and I. van Beijnum, "DNS64: DNS Extensions for Network Address Translation from IPv6 Clients to IPv4 Servers", RFC 6147, April 2011. Savolainen & Korhonen Expires January 11, 2012 [Page 7] Internet-Draft NSP Discovery using WKN July 2011 Authors' Addresses Teemu Savolainen Nokia Hermiankatu 12 D FI-33720 Tampere Finland Email: teemu.savolainen@nokia.com Jouni Korhonen Nokia Siemens Networks Linnoitustie 6 FI-02600 Espoo Finland Email: jouni.nospam@gmail.com Savolainen & Korhonen Expires January 11, 2012 [Page 8]