Internet-Draft In the DNS, QDCOUNT is (usually) One October 2023
Bellis & Abley Expires 15 April 2024 [Page]
Workgroup:
DNSOP Working Group
Internet-Draft:
draft-ietf-dnsop-qdcount-is-one-00
Updates:
RFC1035 (if approved)
Published:
Intended Status:
Standards Track
Expires:
Authors:
R. Bellis
ISC
J. Abley
Cloudflare

In the DNS, QDCOUNT is (usually) One

Abstract

This document clarifies the allowable values of the QDCOUNT parameter in DNS messages with OPCODE = 0 (QUERY) and specifies the required behaviour when values that are not allowed are encountered.

Status of This Memo

This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.

Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at https://datatracker.ietf.org/drafts/current/.

Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."

This Internet-Draft will expire on 15 April 2024.

Table of Contents

1. Introduction

The DNS protocol [RFC1034][RFC1035] includes a parameter QDCOUNT in the DNS message header, whose value is specified to mean the number of questions in the Question Section of a message.

In a general sense it seems perfectly plausible for the QDCOUNT parameter, an unsigned 16-bit value, to take a considerable range of values. However, in the specific case of messages that encode DNS queries and responses (messages with OPCODE = 0) there are other limitations inherent in the protocol that constrain values of QDCOUNT to be either 0 or 1. In particular, several parameters specified for DNS response messages such as AA and RCODE have no defined meaning when the message contains multiple queries, since there is no way to signal which question those parameters relate to.

In this document we briefly survey the existing written DNS specification; we provide a description of the semantic and practical requirements for DNS queries that naturally constrain the allowable values of QDCOUNT; and we update the DNS base specification to clarify the allowable values of the QDCODE parameter in the specific case of DNS messages with OPCODE = 0 (QUERY).

2. Terminology used in this document

The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in BCP 14 [RFC2119] [RFC8174] when, and only when, they appear in all capitals, as shown here.

3. QDCOUNT is (usually) One

A brief summary of the guidance provided in the existing DNS specification for the use of QDCOUNT can be found in Appendix A. While the specification is clear in many cases, in the specific case of OPCODE = 0 (QUERY) there is some ambiguity which this document aims to eliminate.

4. Updates to RFC 1035

A DNS message with OPCODE = 0 (QUERY) MUST NOT include a QDCOUNT parameter whose value is greater than 1. It follows that the Question Section of a DNS message with OPCODE = 0 MUST NOT contain more than one question.

A DNS message with OPCODE = 0 (QUERY) and QDCOUNT > 1 MUST be treated as an incorrectly-formatted message. The value of the RCODE parameter in the response message MUST be set to 1 (FORMERR).

Firewalls that process DNS messages in order to eliminate unwanted traffic SHOULD treat messages with OPCODE = 0 and QDCOUNT > 1 as malformed traffic. See Section 4 of [RFC8906] for further guidance. Such firewalls MUST NOT treat messages with OPCODE = 0 and QDCOUNT = 0 as malformed.

5. Security Considerations

This document clarifies the DNS specification and aims to improve interoperability between different DNS implementations. In general, the elimination of ambiguity seems well-aligned with security hygiene.

6. IANA Considerations

This document has no IANA actions.

7. Acknowledgements

The clarifications in this document were prompted by questions posed by Ted Lemon, which reminded the authors of earlier, similar questions and motivated them to pick up their pens. Ondrej Sury, Warren Kumari, Peter Thomassen, Mark Andrews, Lars-Johan Liman and Jim Reid provided useful feedback to early drafts.

8. References

8.1. Normative References

[RFC1034]
Mockapetris, P., "Domain names - concepts and facilities", STD 13, RFC 1034, DOI 10.17487/RFC1034, , <https://www.rfc-editor.org/info/rfc1034>.
[RFC1035]
Mockapetris, P., "Domain names - implementation and specification", STD 13, RFC 1035, DOI 10.17487/RFC1035, , <https://www.rfc-editor.org/info/rfc1035>.
[RFC2119]
Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, DOI 10.17487/RFC2119, , <https://www.rfc-editor.org/info/rfc2119>.
[RFC3425]
Lawrence, D., "Obsoleting IQUERY", RFC 3425, DOI 10.17487/RFC3425, , <https://www.rfc-editor.org/info/rfc3425>.
[RFC8174]
Leiba, B., "Ambiguity of Uppercase vs Lowercase in RFC 2119 Key Words", BCP 14, RFC 8174, DOI 10.17487/RFC8174, , <https://www.rfc-editor.org/info/rfc8174>.

8.2. Informative References

[RFC1996]
Vixie, P., "A Mechanism for Prompt Notification of Zone Changes (DNS NOTIFY)", RFC 1996, DOI 10.17487/RFC1996, , <https://www.rfc-editor.org/info/rfc1996>.
[RFC2136]
Vixie, P., Ed., Thomson, S., Rekhter, Y., and J. Bound, "Dynamic Updates in the Domain Name System (DNS UPDATE)", RFC 2136, DOI 10.17487/RFC2136, , <https://www.rfc-editor.org/info/rfc2136>.
[RFC7873]
Eastlake 3rd, D. and M. Andrews, "Domain Name System (DNS) Cookies", RFC 7873, DOI 10.17487/RFC7873, , <https://www.rfc-editor.org/info/rfc7873>.
[RFC8490]
Bellis, R., Cheshire, S., Dickinson, J., Dickinson, S., Lemon, T., and T. Pusateri, "DNS Stateful Operations", RFC 8490, DOI 10.17487/RFC8490, , <https://www.rfc-editor.org/info/rfc8490>.
[RFC8906]
Andrews, M. and R. Bellis, "A Common Operational Problem in DNS Servers: Failure to Communicate", BCP 231, RFC 8906, DOI 10.17487/RFC8906, , <https://www.rfc-editor.org/info/rfc8906>.

Appendix A. Guidance for the use of QDCOUNT in the DNS Specification

The DNS Specification provides some guidance about the values of QDCOUNT that are appropriate in various situations. A brief summary of this guidance is collated below.

A.1. OPCODE = 0 (QUERY) and 1 (IQUERY)

[RFC1035] significantly predates the use of normative requirements keywords, and parts of it are consequently somewhat open to interpretation.

Section 4.1.2 ("Question section format") has this to say about QDCOUNT:

  • The section contains QDCOUNT (usually 1) entries

The only documented exceptions within [RFC1035] relate to the IQuery Opcode, where the request has "an empty question section" (QDCOUNT = 0), and "zero, one, or multiple domain names for the specified resource as QNAMEs in the question section". The IQuery OpCode was made obsolete in [RFC3425].

In the absence of clearly expressed normative requirements, we rely on other text in [RFC1035] that makes use of the definite article or other text that implies a singular question and, by implication, QDCOUNT = 1.

For example, Section 4.1:

  • the question for the name server

and:

  • The question section contains fields that describe a question to a name server

and in Section 4.1.1. ("Header section format"):

  • AA Authoritative Answer - this bit is valid in responses, and specifies that the responding name server is an authority for the domain name in question section.

DNS Cookies [RFC7873] in Section 5.4 allow a client to receive a valid Server Cookie without sending a specific question by sending a Query packet (OpCode 0) with QDCOUNT = 0, with the resulting response also containing no question.

A.2. OPCODE = 4 (NOTIFY)

DNS Notify [RFC1996] also lacks a clearly defined range of values for QDCOUNT. Section 3.7 says:

  • A NOTIFY request has QDCOUNT > 0

but all other text in the RFC talks about the <QNAME, QCLASS, QTYPE> tuple in the singular.

A.3. OPCODE = 5 (UPDATE)

DNS Update [RFC2136] renames the QDCOUNT field to ZOCOUNT, but the value is constrained to be one by Section 2.3 ("Zone Section"):

  • All records to be updated must be in the same zone, and therefore the Zone Section is allowed to contain exactly one record.

A.4. OPCODE = 6 (DNS Stateful Operations, DSO)

DNS Stateful Operations [RFC8490] (DSO - OpCode 6) attempts to preserve compatibility with the standard DNS 12 octet header, and does so by requiring that all four of the section count values be set to zero.

A.5. Conclusion

There is no text in [RFC1035] that describes how other parameters in the DNS message such as AA, RCODE should be interpreted in the case where a message includes more than one question. An originator of a query with QDCOUNT > 1 can have no expectations of how it will be processed, and the receiver of a response with QDCOUNT > 1 has no guidance for how it should be interpreted.

The allowable values of QDCOUNT seem to be clearly specified for OPCODE = 4 (NOTIFY), OPCODE = 5 (UPDATE) and OPCODE = 6 (DNS Stateful Operations, DSO). OPCODE = 1 (IQUERY) is obsolete and OPCODE = 2 (STATUS) is not specified. OPCODE = 3 is reserved.

However, the allowable values of QDCOUNT for OPCODE = 0 (QUERY) are specified in [RFC1035] without the clarity of normative language, and this looseness of language results in some ambiguity.

Authors' Addresses

Ray Bellis
Internet Systems Consortium, Inc.
PO Box 360
Newmarket, NH 03857
United States of America
Joe Abley
Cloudflare
Amsterdam
Netherlands