Internet-Draft | NTPv5 Use Cases and Requirements | January 2024 |
Gruessing | Expires 28 July 2024 | [Page] |
This document describes the use cases, requirements, and considerations that should be factored in the design of a successor protocol to supersede version 4 of the NTP protocol presently referred to as NTP version 5 ("NTPv5"). It aims to define what capabilities and requirements such a protocol possesses, informing the design of the protocol in addition to capturing any working group consensus made in development.¶
RFC Editor: please remove this section before publication¶
Source code and issues for this draft can be found at https://github.com/fiestajetsam/draft-gruessing-ntp-ntpv5-requirements.¶
This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.¶
Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at https://datatracker.ietf.org/drafts/current/.¶
Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."¶
This Internet-Draft will expire on 28 July 2024.¶
Copyright (c) 2024 IETF Trust and the persons identified as the document authors. All rights reserved.¶
This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (https://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Revised BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Revised BSD License.¶
NTP version 4 [RFC5905] has seen active use for over a decade, and within this time period the protocol has not only been extended to support new requirements but has also fallen victim to vulnerabilities that have been used for distributed denial of service (DDoS) amplification attacks. In order to advance the protocol and address these known issues alongside add capabilities for future usage this document defines the current known and applicable use cases in existing NTPv4 deployments and defines requirements for the future.¶
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in BCP 14 [RFC2119] [RFC8174] when, and only when, they appear in all capitals, as shown here.¶
Use of time specific terminology used in this document may further be specified in [RFC7384] or NTP specific terminology and concepts within [RFC5905].¶
As a protocol, NTP is used synchronise large amounts of computers via both private networks and the open internet, and there are several common scenarios for existing NTPv4 deployments: publicly accessible NTP services such as the NTP Pool [ntppool] are used to offer clock synchronisation for end users and embedded devices, ISP-provided servers are used to synchronise devices such as customer-premises equipment. Depending on the network and path these deployments may be affected by variable latency as well as throttling or blocking by providers.¶
Data centres and cloud computing providers have also deployed and offer NTP services both for internal use and for customers, particularly where the network is unable to offer or does not require the capabilities other protocols can provide, and where there may already be familiarity with NTP. As these deployments are less likely to be constrained by network latency or power, the potential for higher levels of accuracy and precision within the bounds of the protocol are possible, particularly through the use of modifications such as the use of bespoke algorithms.¶
A considerable motivation towards a new version of the protocol is the inclusion of security primitives such as authentication and encryption to bring the protocol in-line with current best practices for protocol design.¶
There are numerous potential threats to a deployment or network handling traffic time synchronisation protocols that [RFC7384] section 3 describes, which can be summarised into three basic groups: Denial of Service (DoS), degradation of accuracy, and false time, all of which in various forms apply to NTP. However, not all threats apply specifically to NTP directly, most notable attacks on time sources (section 3.2.10) and L2/L3 DoS Attacks (section 3.2.7) as both are outside the scope of the protocol, and the protocol itself cannot provide much in the way of mitigations.¶
NTPv4 has previously suffered from DDoS amplification attacks using a combination of IP address spoofing and private mode commands used in some NTP implementations, leading to an attacker being able to direct very large volumes of traffic to a victim IP address. Current mitigations are disabling private mode commands susceptible to attacks and encouraging network operators to implement BCP 38 [RFC2827] as well as source address validation where possible.¶
The NTPv5 protocol specification should be designed with current best practices for UDP based protocols in mind [RFC8085]. It should reduce the potential amplification factors in request/response payload sizes [drdos-amplification] through the use of padding of payload data, in addition to restricting command and diagnostic modes which could be exploited.¶
The risk that an on-path attacker can systemically delay packets between a client and server exists in all time protocols operating on insecure networks and its mitigations within the protocol are limited for a clock which is not yet synchronised. Increased path diversity and protocol support for synchronisation across multiple heterogeneous sources are likely the most effective mitigations.¶
Conversely, on-path attackers who can manipulate timestamps could also speed up a client's clock resulting in drift-related malfunctions and errors such as premature expiration of certificates on affected hosts. An attacker may also manipulate other data in flight to disrupt service and cause de-synchronisation. Additionally attacks via replaying previously transmitted packets can also delay or confuse receiving clocks, impacting ongoing synchronisation.¶
Message authentication with regular key rotation should mitigate all of these cases; however deployments should consider finding an appropriate compromise between the frequency of rotation to balance the window of attack and the rate of re-keying.¶
At a high level, NTPv5 should be a protocol that is capable of operating in local networks and over public internet connections where packet loss, delay, and filtering may occur. It should provide both basic time information and synchronisation.¶
Historically there have been many documented instances of NTP servers receiving ongoing large volumes of unauthorised traffic [ntp-misuse] and the design of NTPv5 must ensure the risk of these can be minimised through the use of signalling unwanted traffic (e.g Kiss of Death) or easily identifiable packet formats which make rate-limiting, filtering, or blocking by firewalls possible.¶
The protocol's loop avoidance mechanisms SHOULD be able to use identifiers that change over time. Identifiers MUST NOT relate to network topology, in particular such mechanism should not rely on any FQDN, IP address or identifier tied to a public certificate used or owned by the server. Servers SHOULD be able to migrate and change any identifier used as stratum topologies or network configuration changes occur.¶
An additional identifier mechanism MAY be considered for the purposes of client allow/deny lists, logging and monitoring. Such a mechanism when included, SHOULD be independent of any loop avoidance mechanism, and authenticity requirements SHOULD be considered.¶
The protocol MUST have the capability for servers to notify clients that the service is unavailable and clients MUST have clearly defined behaviours for honouring this signalling. In addition servers SHOULD be able to communicate to clients that they should reduce their query rate when the server is under high load or has reduced capacity.¶
Clients SHOULD periodically re-establish connections with servers to prevent maintaining prolonged connectivity to unavailable hosts and give operators the ability to move traffic away from hosts in a timely manner.¶
The protocol SHOULD have provisions for deployments where Network Address Translation occurs and define behaviours when NAT rebinding occurs. This should also not compromise any DDoS mitigation(s) that the protocol may define.¶
Client and server protocol modes MUST be supported. Other modes such as symmetric and broadcast MAY be supported by the protocol but SHOULD NOT be required by implementers to implement. Considerations should be made in these modes to avoid implementation vulnerabilities and to protect deployments from attacks.¶
To minimise ongoing use of deprecated fields and exposing identifying information of implementations and deployments, payload formats SHOULD use the least amount of fields and information where possible, realising that data minimisation and resource management can be at odds with one another. The use of extensions should be preferred when transmitting optional data.¶
The use of algorithms describing functions such as clock filtering, selection, and clustering SHOULD have agility, allowing for implementations to develop and deploy new algorithms independently. Signalling of algorithm use or preference SHOULD NOT be transmitted by servers, however essential properties of the algorithm (e.g. precision) SHOULD be obvious.¶
The working group should consider creating a separate informational document to describe an algorithm to assist with implementation, and consider adopting future documents which describe new algorithms as they are developed. Specifying client algorithms separately from the protocol will allow NTPv5 to meet the needs of applications with a variety of network properties and performance requirements.¶
The protocol should adopt a linear, monotonic timescale as the basis for communicating time. The format should provide sufficient scale, precision, and resolution to meet or exceed NTPv4's capabilities, and have a roll-over date sufficiently far into the future that the protocol's complete obsolescence is likely to occur first. Ideally it should be similar or identical to the existing epoch and data model that NTPv4 defines to allow for implementations to better support both versions of the protocol, simplifying implementation.¶
The timescale, in addition to any other time-sensitive information, MUST be sufficient to calculate representations of both UTC and TAI [TF.460-6], noting that UTC itself as the current timescale used in NTPv4 is neither linear nor monotonic unlike TAI. Through extensions the protocol SHOULD support additional timescale representations outside of the main specification, and all transmissions of time data MUST indicate the timescale in use.¶
Transmission of UTC leap second information MUST be included in the protocol in order for clients to generate a UTC representation, but must be transmitted as separate information to the timescale. The specification MUST require that servers transmit upcoming leap seconds greater than 24 hours in linear timescale in advance if that information is known by the server. If the server learns of a leap second less than 24 hours before an upcoming leap second event, it MUST start transmitting the information immediately.¶
Smearing [google-smear] of leap seconds SHOULD be supported in the protocol, and the protocol MUST support servers transmitting information if they are configured to smear leap seconds and if they are actively doing so. Behaviours for both client and server in handling leap seconds MUST be part of the specification; in particular how clients handle multiple servers where some may use leap seconds and others smearing, that servers should not apply both leap seconds and smearing, as well as details around smearing timescales. Supported smearing algorithms MUST be defined or referenced.¶
The desire for compatibility with older protocols should not prevent addressing deployment issues or cause ossification of the protocol caused by middleboxes [RFC9065].¶
Servers that support multiple versions of NTP MUST send a response in the same version as the request as the model of backwards compatibility. This does not preclude servers from acting as a client in one version of NTP and a server in another.¶
Protocol ossification MUST be addressed to prevent existing NTPv4 deployments which respond incorrectly to clients posing as NTPv5 from causing issues. Forward prevention of ossification (for a potential NTPv6 protocol in the future) should also be taken into consideration.¶
Many other documents make use of NTP's data formats ([RFC5905] Section 6) for representing time, notably for media and packet timestamp measurements, such as SDP [RFC4566] and STAMP [RFC8762]. Any changes to the data formats should consider the potential implementation complexity that may be incurred.¶
The protocol MUST have the capability to be extended; implementations MUST ignore unknown extensions. Unknown extensions received from a lower stratum server SHALL NOT be re-transmitted towards higher stratum servers.¶
Data authentication and integrity MUST be supported by the protocol, with optional support for data confidentiality. Downgrade attacks by an in-path attacker must be mitigated. The protocol MUST define at least one common mechanism to ensure interoperability, but should also include support for different mechanisms to support different deployment use cases. Extensions and additional modes SHOULD also incorporate authentication and integrity on data which could be manipulated by an attacker, on-path or off-path.¶
Upgrading cryptographic algorithms must be supported, allowing for more secure cryptographic primitives to be incorporated as they are developed and as attacks and vulnerabilities with incumbent primitives are discovered.¶
Intermediate devices such as networking equipment capable of modifying NTP packets, for example to adjust timestamps MUST be able to do so without compromising authentication or confidentiality. Extension fields with separate authentication may be used to facilitate this.¶
Consideration must be given to how this will be incorporated into any applicable trust model. Downgrading attacks that could lead to an adversary disabling or removing encryption or authentication MUST NOT be possible in the design of the protocol.¶
This section covers topics that are explicitly out of scope.¶
Detection and reporting of server malfeasance should remain out of scope as [I-D.ietf-ntp-roughtime] already provides this capability as a core functionality of the protocol.¶
Previous versions of NTP do not transmit additional time information such as time zone data or historical leap seconds, and NTPv5 should not explicitly add support for it by default as existing protocols (e.g. TZDIST [RFC7808]) already provide mechanisms to do so. This does not prevent however, further extensions enabling this.¶
Largely due to previous DDoS amplification attacks, mode 6 messages which have historically provided the ability for monitoring of servers SHOULD NOT be supported in the core of the protocol. However, it may be provided as a separate extension specification. It is likely that even with a new version of the protocol middleboxes may continue to block this mode in default configurations into the future.¶
This document makes no requests of IANA.¶
As this document is intended to create discussion and consensus, it introduces no security considerations of its own.¶
The author would like to thank Doug Arnold, Hal Murray, Paul Gear, and David Venhoek for contributions to this document, and would like to acknowledge Daniel Franke, Watson Ladd, Miroslav Lichvar for their existing documents and ideas. The author would also like to thank Angelo Moriondo, Franz Karl Achard, and Malcom McLean for providing the author with motivation.¶