Network Working Group G. Shieh Internet-Draft J. Uberti Intended status: Standards Track Google Expires: April 21, 2016 October 19, 2015 WebRTC IP Address Handling Recommendations draft-shieh-rtcweb-ip-handling-00 Abstract This document provides best practices for how IP addresses should be handled by WebRTC applications. Status of This Memo This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79. Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet- Drafts is at http://datatracker.ietf.org/drafts/current/. Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress." This Internet-Draft will expire on April 21, 2016. Copyright Notice Copyright (c) 2015 IETF Trust and the persons identified as the document authors. All rights reserved. This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (http://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License. Shieh & Uberti Expires April 21, 2016 [Page 1] Internet-Draft WebRTC IP Handling October 2015 Table of Contents 1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . 2 2. Problem Statement . . . . . . . . . . . . . . . . . . . . . . 2 3. Goals . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 4. Detailed Design . . . . . . . . . . . . . . . . . . . . . . . 4 5. Application Guidance . . . . . . . . . . . . . . . . . . . . 5 6. Security Considerations . . . . . . . . . . . . . . . . . . . 6 7. IANA Considerations . . . . . . . . . . . . . . . . . . . . . 6 8. Acknowledgements . . . . . . . . . . . . . . . . . . . . . . 6 Authors' Addresses . . . . . . . . . . . . . . . . . . . . . . . 6 1. Introduction As a technology that supports peer-to-peer connections, WebRTC may send data over different network paths than the path used for HTTP traffic. This may allow a web application to learn additional information about the user, which may be problematic in certain cases. This document summarizes the concerns, and makes recommendations on how best to handle the tradeoff between privacy and media performance. 2. Problem Statement WebRTC enables real-time peer-to-peer communications by enumerating network interfaces and discovering the best route through the ICE protocol. During the ICE process, the peers involved in a session gather and exchange all the IP addresses they can discover, so that the connectivity of each IP pair can be checked, and the best path chosen. The addresses that are gathered usually consist of an endpoint's private physical/virtual addresses, and its public Internet addresses. These addresses are exposed upwards to the web application, so that they can be communicated to the remote endpoint. This allows the application to learn more about the local network configuration than it would from a typical HTTP scenario, in which the web server would only see a single public Internet address, i.e. the address from which the HTTP request was sent. The information revealed falls into three categories: (1) If the client is behind a NAT, the client's private IP addresses, typically RFC 1918 addresses, can be learned. (2) If the client tries to hide its physical location through a VPN, and the VPN and local OS supports routing over multiple interfaces, WebRTC will discover the public address associated Shieh & Uberti Expires April 21, 2016 [Page 2] Internet-Draft WebRTC IP Handling October 2015 with both the VPN as well as the ISP public address over that the VPN runs over. (3) If the client is behind a proxy, but direct access to the Internet is also supported, WebRTC's STUN checks will bypass the proxy and reveal the public address of the client. Of these three concerns, #2 is the most significant concern, since for some users, the purpose of using a VPN is for anonymity. However, different VPN users will have different needs, and some VPN users (e.g. corporate VPN users) may in fact prefer WebRTC to send media traffic directly, i.e. not through the VPN. #3 is a less common concern, as proxy administrators can control this behavior through local firewall policy if desired, coupled with the fact that forcing WebRTC traffic through a proxy will have negative effects on both the proxy and on media quality. #1 is considered to be the least significant concern, given that the local address values often contain minimal information (e.g. 192.168.0.2), or have built-in privacy protection (e.g. RFC 4941 IPv6 addresses). Note also that these concerns predate WebRTC; Adobe Flash Player has provided similar functionality since the introduction of RTMFP in 2008. 3. Goals Being peer-to-peer, WebRTC represents a privacy-enabling technology, and therefore we want to avoid solutions that disable WebRTC or make it harder to use. This means that WebRTC should be configured by default to only reveal the minimum amount of information needed to establish a performant WebRTC session, while providing options to reveal additional information upon user consent, or further limit this information if the user has specifically requested this. Specifically, WebRTC should: o Provide a privacy-friendly default behavior which strikes the right balance between privacy and media performance for most users and use cases. o For users who care more about one versus the other, provide means to customize the experience. Shieh & Uberti Expires April 21, 2016 [Page 3] Internet-Draft WebRTC IP Handling October 2015 4. Detailed Design The main ideas for the design are the following: o By default, WebRTC should follow the route for HTTP traffic, when this is easy to determine (i.e. not considering proxies). This is accomplished by binding local sockets to the "any" addresses (0.0.0.0 for IPv4, :: for IPv6), which allows the OS to route WebRTC traffic the same way as normal HTTP traffic, and allows only the 'typical' public addresses to be discovered. o By default, support for host-host connections should be maintained. Even when binding to "any" addresses, the local IPv4 and IPv6 addresses of the interface used for outgoing STUN traffic should still be surfaced as candidates; this is necessary for certain peer-to-peer data channel apps to function correctly. The appropriate addresses here can be discovered by binding sockets to the "any" addresses, connect()ing those sockets to a public destination (e.g. "8.8.8.8"), and then reading the bound local addresses via getsockname(). o WebRTC incorporates an explicit permission grant for access to local audio and video, which are typically much more sensitive than the aforementioned IP address information. If the user has consented to media access, this should also allow WebRTC to gather all possible candidates and determine the absolute best route for media traffic. o Determining whether a proxy is in use is a complex process, as the answer can depend on the exact site or address being contacted. Furthermore, proxies that support UDP are not widely deployed today. Therefore, the only way to ensure that WebRTC traffic traverses a proxy is to force WebRTC to use ICE-TCP or TURN-over- TCP, and always try to make the TCP connection through the proxy, if one exists. Naturally, this will have attendant costs on media quality and also proxy performance. Based on these ideas, we define four modes of WebRTC behavior, reflecting different privacy/media tradeoffs: Mode 1 Enumerate all addresses: WebRTC will bind to all interfaces individually and use them all to ping STUN servers or peers. This will converge on the best media path, and is ideal when media performance is the highest priority, but it discloses the most information. As such, this should only be performed when the user has explicitly given consent for local media access, as indicated in design idea #3 above. Shieh & Uberti Expires April 21, 2016 [Page 4] Internet-Draft WebRTC IP Handling October 2015 Mode 2 Default route + the single associated local address: By binding solely to the "any" address, media packets will flow through the same route as normal HTTP traffic. In addition, the associated private address is discovered through getsockname, as mentioned above. This ensures that direct connections can still be established even when local media access is not granted, e.g. for data channel applications. Mode 3 Default route only: This is the the same as Mode 2, except that the associated private address is not provided, which may cause traffic to hairpin through NAT or fall back to the application TURN server, with resulting quality implications. Mode 4 Force TCP and proxy: This is disables any use of UDP and forces use of TCP to connect to the TURN server or peer. If a proxy server is configured, the TCP traffic will be sent through the proxy, with resulting quality implications. We recommend Mode 1 as the default behavior only if cam/mic permission has been granted, or Mode 2 if this is not the case. Users who prefer Mode 3 or 4 should be able to select a preference or install an extension to force their browser to operate in the specified mode. For example, Chrome users can install the WebRTC Network Limiter extension for this configuration. 5. Application Guidance The recommendations mentioned in this document may cause breakage to certain WebRTC applications. In order to be robust in all scenarios, applications should follow the following guidelines: o Applications should deploy a TURN server with support for both UDP and TCP connections to the server. This ensures that connectivity can still be established, even when Mode 3 or Mode 4 are in use. o Applications can detect when they don't have access to the full set of ICE candidates by checking for the presence of host candidates. If no host candidates are present, Mode 3 or 4 above is in use. o Future versions of browsers may present an indicator to signify that the page is using WebRTC to set up a peer-to-peer connection. Applications should be careful to only use WebRTC in a fashion that is consistent with user expectations. Shieh & Uberti Expires April 21, 2016 [Page 5] Internet-Draft WebRTC IP Handling October 2015 6. Security Considerations This document is entirely devoted to security considerations. 7. IANA Considerations This document requires no actions from IANA. 8. Acknowledgements Several people provided input into this document, including Harald Alvestrand, Ted Hardie, Matthew Kaufmann, and Eric Rescorla. Authors' Addresses Guo-wei Shieh Google 747 6th Ave S Kirkland, WA 98033 USA Email: guoweis@google.com Justin Uberti Google 747 6th Ave S Kirkland, WA 98033 USA Email: justin@uberti.name Shieh & Uberti Expires April 21, 2016 [Page 6]