Network Working Group D. Schinazi Internet-Draft Google LLC Intended status: Experimental 16 April 2020 Expires: 18 October 2020 The CONNECT-UDP HTTP Method draft-schinazi-masque-connect-udp-00 Abstract This document describes the CONNECT-UDP HTTP method. CONNECT-UDP is similar to the HTTP CONNECT method, but it uses UDP instead of TCP. Discussion of this work is encouraged to happen on the MASQUE IETF mailing list masque@ietf.org or on the GitHub repository which contains the draft: https://github.com/DavidSchinazi/masque-drafts. Status of This Memo This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79. Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet- Drafts is at https://datatracker.ietf.org/drafts/current/. Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress." This Internet-Draft will expire on 18 October 2020. Copyright Notice Copyright (c) 2020 IETF Trust and the persons identified as the document authors. All rights reserved. This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (https://trustee.ietf.org/ license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License. Schinazi Expires 18 October 2020 [Page 1] Internet-Draft CONNECT-UDP April 2020 Table of Contents 1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . 2 1.1. Conventions and Definitions . . . . . . . . . . . . . . . 2 2. Supported HTTP Versions . . . . . . . . . . . . . . . . . . . 2 3. The CONNECT-UDP Method . . . . . . . . . . . . . . . . . . . 3 4. Encoding of Proxied UDP Packets . . . . . . . . . . . . . . . 4 5. Datagram-Flow-Id Header Definition . . . . . . . . . . . . . 5 6. Server Handling . . . . . . . . . . . . . . . . . . . . . . . 5 7. Security Considerations . . . . . . . . . . . . . . . . . . . 5 8. IANA Considerations . . . . . . . . . . . . . . . . . . . . . 5 8.1. HTTP Method . . . . . . . . . . . . . . . . . . . . . . . 5 8.2. HTTP Header . . . . . . . . . . . . . . . . . . . . . . . 6 9. Normative References . . . . . . . . . . . . . . . . . . . . 6 Acknowledgments . . . . . . . . . . . . . . . . . . . . . . . . . 7 Author's Address . . . . . . . . . . . . . . . . . . . . . . . . 7 1. Introduction This document describes the CONNECT-UDP HTTP method. CONNECT-UDP is similar to the HTTP CONNECT method (see section 4.3.6 of [RFC7231]), but it uses UDP [UDP] instead of TCP [TCP]. Discussion of this work is encouraged to happen on the MASQUE IETF mailing list masque@ietf.org or on the GitHub repository which contains the draft: https://github.com/DavidSchinazi/masque-drafts. 1.1. Conventions and Definitions The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in BCP 14 [RFC2119] [RFC8174] when, and only when, they appear in all capitals, as shown here. 2. Supported HTTP Versions The CONNECT-UDP method is defined for all versions of HTTP. When the HTTP version used runs over QUIC [QUIC], UDP payloads can be sent over QUIC DATAGRAM frames [DGRAM]. Otherwise they are sent on the stream where the CONNECT-UDP request was made. Note that when multiple proxies are involved in a CONNECT-UDP request, all the HTTP connections along the path need to be using HTTP/3 [H3] or later in order for UDP payloads to be sent over QUIC DATAGRAM frames. Additionally, when the HTTP version in use does not support multiplexing streams (such as HTTP/1.1), then any reference to "stream" in this document is meant to represent the entire connection. Schinazi Expires 18 October 2020 [Page 2] Internet-Draft CONNECT-UDP April 2020 3. The CONNECT-UDP Method The CONNECT-UDP method requests that the recipient establish a tunnel over a single HTTP stream to the destination origin server identified by the request-target and, if successful, thereafter restrict its behavior to blind forwarding of packets, in both directions, until the tunnel is closed. Tunnels are commonly used to create an end-to- end virtual connection, through one or more proxies, which can then be secured using QUIC or another protocol running over UDP. A client sending a CONNECT-UDP request MUST send the authority form of request-target (Section 5.3 of [RFC7230]); i.e., the request- target consists of only the host name and port number of the tunnel destination, separated by a colon. For example, CONNECT-UDP server.example.com:443 HTTP/1.1 Host: server.example.com:443 When using HTTP/2 [H2] or later, CONNECT-UDP requests use HTTP pseudo-headers with the following requirements: * The ":method" pseudo-header field is set to "CONNECT-UDP". * The ":scheme" and ":path" pseudo-header fields MUST be omitted. * The ":authority" pseudo-header field contains the host and port to connect to (equivalent to the authority-form of the request-target of CONNECT-UDP requests (see [RFC7230], Section 5.3)). A CONNECT-UDP request that does not conform to these restrictions is malformed (see [H2], Section 8.1.2.6). The recipient proxy can establish a tunnel either by directly opening a UDP socket to the request-target or, if configured to use another proxy, by forwarding the CONNECT-UDP request to the next inbound proxy. Any 2xx (Successful) response indicates that the sender (and all inbound proxies) will switch to tunnel mode immediately after the blank line that concludes the successful response's header section; data received after that blank line is from the server identified by the request-target. Any response other than a successful response indicates that the tunnel has not yet been formed and that the connection remains governed by HTTP. A tunnel is closed when a tunnel intermediary detects that either side has closed its connection: the intermediary MUST attempt to send any outstanding data that came from the closed side to the other side, close both connections, and then discard any remaining data left undelivered. Schinazi Expires 18 October 2020 [Page 3] Internet-Draft CONNECT-UDP April 2020 A server MUST NOT send any Transfer-Encoding or Content-Length header fields in a 2xx (Successful) response to CONNECT. A client MUST treat a response to CONNECT-UDP containing any Content-Length or Transfer-Encoding header fields as malformed. A payload within a CONNECT-UDP request message has no defined semantics; a CONNECT-UDP request with a non-empty payload is malformed. Responses to the CONNECT-UDP method are not cacheable. 4. Encoding of Proxied UDP Packets When the HTTP connection between client and proxy supports HTTP/3 datagrams [H3DGRAM], UDP packets can be encoded using QUIC DATAGRAM frames. This support is ascertained by checking receipt of the H3_DATAGRAM SETTINGS Parameter. Note that when there are multiple proxies involved, this support needs to be ascertained on all the HTTP connections that will carry proxied UDP packets. If the client supports HTTP/3 datagrams and has received the H3_DATAGRAM SETTINGS Parameter on this connection, it SHOULD attempt to use HTTP/3 datagrams. This is accomplished by requesting a datagram flow identifier from the flow identifier allocation service [H3DGRAM]. That service generates an even flow identifier, and the client sends it to the server by using the "Datagram-Flow-Id" header (see Section 5). If there are multiple proxies involved, proxies along the chain MUST check whether their upstream connection supports HTTP/3 datagrams. If it does not, that proxy MUST remove the "Datagram-Flow-Id" header before forwarding the CONNECT-UDP request. The proxy that is creating the UDP socket to the destination responds to the CONNECT-UDP request with a 2xx (Successful) response, and MUST echo the "Datagram-Flow-Id" header. Once the client has received the "Datagram-Flow-Id" header on the successful response, it knows that it can use the HTTP/3 datagram encoding to send proxied UDP packets for this particular destination. It then encodes the payload of UDP datagrams into the payload of HTTP/3 datagrams. Clients MAY optimistically start sending proxied UDP packets before receiving the response to its CONNECT-UDP request, noting however that those may not be processed by the proxy if it responds to the CONNECT-UDP request with a failure, or if they arrive before the CONNECT-UDP request. Schinazi Expires 18 October 2020 [Page 4] Internet-Draft CONNECT-UDP April 2020 If HTTP/3 datagrams are not supported, the stream is used to convey UDP payloads, by prefixing them with a 16-bit length. 5. Datagram-Flow-Id Header Definition "Datagram-Flow-Id" is a Item Structured Header [STRUCT-HDR]. Its value MUST be an Integer. Its ABNF is: Datagram-Flow-Id = sh-integer 6. Server Handling Unlike TCP, UDP is connection-less. The HTTP server that opens the UDP socket has no way of knowing whether the destination is reachable. Therefore it needs to respond to the CONNECT-UDP request without waiting for a TCP SYN-ACK. Servers can use connected UDP sockets if their operating system supports them, as that allows the HTTP server to rely on the kernel to only send it UDP packets that match the correct 5-tuple. If the server uses a non-connected socket, it MUST validate the IP source address and UDP source port on received packets to ensure they match the client's CONNECT-UDP request. Packets that do not match MUST be discarded by the server. 7. Security Considerations There are significant risks in allowing arbitrary clients to establish a tunnel to arbitrary servers, as that could allow bad actors to send traffic and have it attributed to the proxy. Proxies that support CONNECT-UDP SHOULD restrict its use to authenticated users. 8. IANA Considerations 8.1. HTTP Method This document will request IANA to register "CONNECT-UDP" in the HTTP Method Registry (IETF review) maintained at . +-------------+------+------------+---------------+ | Method Name | Safe | Idempotent | Reference | +-------------+------+------------+---------------+ | CONNECT-UDP | no | no | This document | +-------------+------+------------+---------------+ Schinazi Expires 18 October 2020 [Page 5] Internet-Draft CONNECT-UDP April 2020 8.2. HTTP Header This document will request IANA to register the "Datagram-Flow-Id" header in the "Permanent Message Header Field Names" registry maintained at . +-------------------+----------+--------+---------------+ | Header Field Name | Protocol | Status | Reference | +-------------------+----------+--------+---------------+ | Datagram-Flow-Id | http | exp | This document | +-------------------+----------+--------+---------------+ 9. Normative References [DGRAM] Pauly, T., Kinnear, E., and D. Schinazi, "An Unreliable Datagram Extension to QUIC", Work in Progress, Internet- Draft, draft-ietf-quic-datagram-00, 26 February 2020, . [H2] Belshe, M., Peon, R., and M. Thomson, Ed., "Hypertext Transfer Protocol Version 2 (HTTP/2)", RFC 7540, DOI 10.17487/RFC7540, May 2015, . [H3] Bishop, M., "Hypertext Transfer Protocol Version 3 (HTTP/3)", Work in Progress, Internet-Draft, draft-ietf- quic-http-27, 21 February 2020, . [H3DGRAM] Schinazi, D., "Using QUIC Datagrams with HTTP/3", Work in Progress, Internet-Draft, draft-schinazi-quic-h3-datagram- 03, 12 March 2020, . [QUIC] Iyengar, J. and M. Thomson, "QUIC: A UDP-Based Multiplexed and Secure Transport", Work in Progress, Internet-Draft, draft-ietf-quic-transport-27, 21 February 2020, . [RFC2119] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, DOI 10.17487/RFC2119, March 1997, . Schinazi Expires 18 October 2020 [Page 6] Internet-Draft CONNECT-UDP April 2020 [RFC7230] Fielding, R., Ed. and J. Reschke, Ed., "Hypertext Transfer Protocol (HTTP/1.1): Message Syntax and Routing", RFC 7230, DOI 10.17487/RFC7230, June 2014, . [RFC7231] Fielding, R., Ed. and J. Reschke, Ed., "Hypertext Transfer Protocol (HTTP/1.1): Semantics and Content", RFC 7231, DOI 10.17487/RFC7231, June 2014, . [RFC8174] Leiba, B., "Ambiguity of Uppercase vs Lowercase in RFC 2119 Key Words", BCP 14, RFC 8174, DOI 10.17487/RFC8174, May 2017, . [STRUCT-HDR] Nottingham, M. and P. Kamp, "Structured Field Values for HTTP", Work in Progress, Internet-Draft, draft-ietf- httpbis-header-structure-17, 15 March 2020, . [TCP] Postel, J., "Transmission Control Protocol", STD 7, RFC 793, DOI 10.17487/RFC0793, September 1981, . [UDP] Postel, J., "User Datagram Protocol", STD 6, RFC 768, DOI 10.17487/RFC0768, August 1980, . Acknowledgments This proposal was inspired directly or indirectly by prior work from many people. The author would like to thank Eric Rescorla for suggesting to use an HTTP method to proxy UDP. Author's Address David Schinazi Google LLC 1600 Amphitheatre Parkway Mountain View, California 94043, United States of America Email: dschinazi.ietf@gmail.com Schinazi Expires 18 October 2020 [Page 7]