2.3.21 Source Address Validation Improvements (savi)

NOTE: This charter is a snapshot of the 72nd IETF Meeting in Dublin, Ireland. It may now be out-of-date.

Last Modified: 2008-02-19

Chair(s):

Danny McPherson <danny@arbor.net>
Christian Vogt <christian.vogt@ericsson.com>

Internet Area Director(s):

Jari Arkko <jari.arkko@piuha.net>
Mark Townsley <townsley@cisco.com>

Internet Area Advisor:

Jari Arkko <jari.arkko@piuha.net>

Mailing Lists:

General Discussion:
To Subscribe:
Archive:

Description of Working Group:

While ingress filtering [RFC 2827, BCP 38] provides a way to validate
IP source addresses at an aggregated level, there is not yet a
standardized mechanism for IP source address validation at a finer
granularity. Having a finer granularity would be helpful in a number
of situations, including filtering traffic from customer interfaces
implemented as ports in a layer 3 aware bridge or a router, general
improvements in filtering accuracy in enterprise networks, etc.
Depending on the situation, there may be a requirement for blocking
spoofed packets or merely logging packets that appear to be spoofed.

Partial solutions exist to prevent nodes from spoofing the IP source
address of another node in the same IP link (e.g., the "IP source
guard"), but are proprietary. The purpose of the proposed "Source
Address Validation Improvements" working group is to standardize
mechanisms that prevent nodes attached to the same IP link from
spoofing each other's IP addresses.

The scope of the WG is as follows:

- The working group considers only solutions implemented on systems
located on the same IP link as a to-be-verified node. The goal of the
working group is the LAN environment and solutions running in routers or
layer 3 aware Ethernet bridges.

- Both IPv4 and IPv6 need to be covered.

- The first goal of the working group is on unicast traffic, but
using the same mechanisms to police multicast traffic is also
within the scope.

- All address assignment mechanisms need to be supported, including
stateless, stateful, and manual configuration; as well as privacy and
cryptographically generated addresses.

- Solutions are preferably based on observing user traffic, or on
observing or using existing signaling protocols. Examples of
protocols that can be useful to observe/use are ARP, Neighbor
Discovery, DHCP, and DHCP Prefix Delegation protocols. Observing
addresses in IP headers can also be useful. The gathered
information is used to determine what IP source addresses in
packets are appropriate. Where automatic operation is impossible
or would lead to sub-optimal validation results, solutions may
require manual configuration.

- Interdomain scenarios (across Autonomous Systems) that require
information from routing protocols like BGP are out of scope.
Nevertheless, solution may observe routing protocol signaling
to detect that a device is a router.

- Tracking other protocols is not within the scope of the WG.

- No changes to hosts are allowed.

- The WG is prohibited from creating its own protocols
or extensions/modifications of current protocols.

These limitations in the scope may be relaxed through later
rechartering. For instance, solutions tailored for PPP links
and specific environments may be added later, or solutions
involving co-operation of the nodes on the link may be
developed once the baseline solutions have been completed.
However, the WG is already chartered to work also on a
solution for Ethernet-based broadband access networks that
are used in DSL environments. This work is a specialization
of the working group's primary LAN-based solution.

In order to reach a result that is widely usable and unlikely to
disturb existing network practices, the working group needs to
take into account

- nodes that use static addresses,
- nodes with multiple IP addresses on the same interface,
- nodes that use multiple link-layer addresses on the same interface,
- nodes that have multiple interfaces to the same link,
- attachment of another bridge at a bridge port,
- presence of routers, NATs, and other similar devices on the same link,
including their distinction from hosts with multiple interfaces or
hosts with multiple IP addresses on a single interface,
- use of SEcure Neighbor Discovery in some networks,
- nodes that move to another port on the same link, and
- hosts with anycast addresses.

However, should such wide applicability turn out to be impossible,
the working group will document the limitations of the solutions
in due manner. In particular, it is likely that anycast addressing
and nodes that employ multiple interfaces for load balancing at
link layer are indistinguishable from an actual spoofing attack.
There may also be a difference in the applicability between blocking
and merely logging spoofed packets. In any case, the solutions
may require to be explicitly turned on for each network or interface
where they are applicable.

For background information, the working group will also develop a
threats analysis document that describes what threats the solutions
from the WG protect against. This document also contrasts SAVI
to existing solutions.

Goals and Milestones:

No Current Internet-Drafts

No Request For Comments

Meeting Minutes


Slides

Charter and Goals of the SAVI Working Group
SAVI Design Taxonomy & Analysis
SAVI IP Source Guard
A Solution For Source Address Validation in First Hop, Local Subnet Environment
A CGA based Source Address Authorization and Authentication (CSA) for First Layer-3 Hop
SAVI Thoughts