Network Working Group G. Halwasia Internet-Draft S. Bhandari Intended status: Standards Track W. Dec Expires: June 17, 2013 Cisco Systems December 14, 2012 Client Link-layer Address Option in DHCPv6 draft-ietf-dhc-dhcpv6-client-link-layer-addr-opt-04 Abstract This document specifies the format and mechanism that is to be used for encoding client link-layer address in DHCPv6 Relay-Forward messages by defining a new DHCPv6 Client Link-layer Address option. Requirements Language The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in RFC 2119 [RFC2119]. Status of this Memo This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79. Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet- Drafts is at http://datatracker.ietf.org/drafts/current/. Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress." This Internet-Draft will expire on June 17, 2013. Copyright Notice Copyright (c) 2012 IETF Trust and the persons identified as the document authors. All rights reserved. This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (http://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents Halwasia, et al. Expires June 17, 2013 [Page 1] Internet-Draft DHCPv6 client link-layer address option December 2012 carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License. Table of Contents 1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . 3 2. Problem Background and Scenario . . . . . . . . . . . . . . . . 3 3. DHCPv6 Client Link-layer Address Option . . . . . . . . . . . . 4 4. DHCPv6 Relay Agent Behavior . . . . . . . . . . . . . . . . . . 4 5. DHCPv6 Server Behavior . . . . . . . . . . . . . . . . . . . . 5 6. IANA Considerations . . . . . . . . . . . . . . . . . . . . . . 5 7. Security Considerations . . . . . . . . . . . . . . . . . . . . 5 8. Acknowledgements . . . . . . . . . . . . . . . . . . . . . . . 6 9. References . . . . . . . . . . . . . . . . . . . . . . . . . . 6 9.1. Normative References . . . . . . . . . . . . . . . . . . . 6 9.2. Informative References . . . . . . . . . . . . . . . . . . 6 Authors' Addresses . . . . . . . . . . . . . . . . . . . . . . . . 6 Halwasia, et al. Expires June 17, 2013 [Page 2] Internet-Draft DHCPv6 client link-layer address option December 2012 1. Introduction This specification defines an optional mechanism and the related DHCPv6 option to allow first-hop DHCPv6 relay agents (relay agents that are connected to the same link as the client) to provide the client's link-layer address in the DHCPv6 messages being sent towards the server. 2. Problem Background and Scenario DHCPv4 protocol specification [RFC2131] provides a way to specify the client link-layer address in the DHCPv4 message header. DHCPv4 message header has 'htype' and 'chaddr' fields to specify client link-layer address type and link-layer address respectively. The client link-layer address thus learnt can be used by DHCPv4 server and relay in different ways. In some of the deployments DHCPv4 servers use 'chaddr' as a customer identifier and a key for lookup in the client lease database. With the incremental deployment of IPv6 to existing IPv4 networks, which results in a dual-stack network environment, there will be devices that act as both DHCPv4 and DHCPv6 clients. In service provider deployments, a typical DHCPv4 implementation will use the client link-layer address as one of the keys to build DHCP client lease database. In dual stack scenarios operators need to be able to associate DHCPv4 and DHCPv6 messages with the same client interface, based on an identifier that is common to the interface. The client link-layer address is such an identifier. Currently, the DHCPv6 protocol specification [RFC3315] does not define a way to communicate the client link-layer address to the DHCP server in cases where the DHCP server is not connected to the same network link as the DHCP client. DHCPv6 protocol specification mandates all clients to prepare and send DUID as the client identifier option in all the DHCPv6 message exchange. However none of these methods provide a simple way to extract client's link-layer address. This presents a problem to an operator who is using an existing DHCPv4 system with the client link-layer address as the customer identifier, and desires to correlate DHCPv6 assignments using the same identifier. [RFC4361] describes a mechanism for using the same DUID in both DHCPv4 and DHCPv6. Unfortunately, this specification requires modification of existing DHCPv4 clients, and has not seen broad adoption in the industry (indeed, we are not aware of any commercial implementations). Providing an option in DHCPv6 Relay-Forward messages to carry client link-layer address explicitly will help above mentioned scenarios. Halwasia, et al. Expires June 17, 2013 [Page 3] Internet-Draft DHCPv6 client link-layer address option December 2012 For e.g. it can be used along with other identifiers to associate DHCPv4 and DHCPv6 messages from a dual stack client. Further, having client link-layer address in DHCPv6 will help in proving additional information in event debugging and logging related to the client at relay and server. The proposed option may be used in wide range of networks, two notable deployment models are service provider and enterprise network environments. 3. DHCPv6 Client Link-layer Address Option The format of the DHCPv6 Client Link-layer Address option is shown below. 0 1 2 3 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | OPTION_CLIENT_LINKLAYER_ADDR | option-length | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | link-layer type (16 bits) | | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | | link-layer address (variable length) | | | | | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ option-code: OPTION_CLIENT_LINKLAYER_ADDR (TBD) option-length: 2 + length of link-layer address link-layer type: Client Link-layer address type. The link-layer type MUST be a valid hardware type assigned by the IANA, as described in [RFC0826] link-layer address: Client Link-layer address. 4. DHCPv6 Relay Agent Behavior DHCPv6 Relay agents which receive messages originating from clients (for example Solicit and Request, but not, for example, Relay-Forward or Advertise) MAY include the link-layer source address of the received DHCPv6 message in Client Link-layer Address option in relayed DHCPv6 Relay-Forward messages. The DHCPv6 Relay agent behavior can depend on configuration that decides whether the Client Link-layer Address option needs to be included. Halwasia, et al. Expires June 17, 2013 [Page 4] Internet-Draft DHCPv6 client link-layer address option December 2012 5. DHCPv6 Server Behavior If DHCPv6 Server is configured to store or use client link-layer address, it SHOULD look for the client link-layer address option in the Relay-Forward DHCP message of the DHCPv6 Relay agent closest to the client. The mechanism described in this document is not necessary in the case where the DHCPv6 Server is connected to the same network link as the client, because the server can obtain the link-layer address from the link-layer header of the DHCPv6 message. There is no requirement that a server return this option and its data in a downstream DHCP message. 6. IANA Considerations IANA is requested to assign an option code to OPTION_CLIENT_LINKLAYER_ADDR from the "DHCP Option Codes" registry (http://www.iana.org/assignments/dhcpv6-parameters/dhcpv6- parameters.xml). 7. Security Considerations It is possible for a rogue DHCPv6 relay agent to insert an incorrect Client Link Layer Address option for malicious purposes. A DHCPv6 client can also pose as a rogue DHCP relay agent, sending a Relay- Forward message containing an incorrect Client Link Layer Address option. In either case, it would be possible for a DHCPv6 client to masquerade as the same device as a DHCPv4 client, when in fact the two are distinct. One possible attack that could be accomplished using this masquerade would be in the case where a DHCPv4 client is using DHCPv4 to do a Dynamic DNS update to install an A record so that it can be reached by other nodes [RFC4702]. A masquerading DHCPv6 client could use DHCPv6 to install an AAAA record with the same name [RFC4704]. Dual- stack nodes attempting to connect to the DHCPv4 client might then be tricked into connecting to the masquerading DHCPv6 client instead. It is possible that there are other attacks that could be accomplished using this masquerading technique, although the authors are not aware of any. To prevent masquerades of this sort, DHCP server administrators are strongly advised to configure DHCP servers that use this option to communicate with their relay agents using IPsec as described in Section 21.1 of [RFC3315]. Halwasia, et al. Expires June 17, 2013 [Page 5] Internet-Draft DHCPv6 client link-layer address option December 2012 8. Acknowledgements Many thanks to Ted Lemon, Bernie Volz, Hemant Singh, Simon Hobson, Tina TSOU, Andre Kostur, Chuck Anderson, Steinar Haug, Niall O'Reilly, Jarrod Johnson, Tomek Mrugalski and Vincent Zimmer for their input and review. 9. References 9.1. Normative References [RFC0826] Plummer, D., "Ethernet Address Resolution Protocol: Or converting network protocol addresses to 48.bit Ethernet address for transmission on Ethernet hardware", STD 37, RFC 826, November 1982. [RFC2119] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, March 1997. [RFC3315] Droms, R., Bound, J., Volz, B., Lemon, T., Perkins, C., and M. Carney, "Dynamic Host Configuration Protocol for IPv6 (DHCPv6)", RFC 3315, July 2003. [RFC4361] Lemon, T. and B. Sommerfeld, "Node-specific Client Identifiers for Dynamic Host Configuration Protocol Version Four (DHCPv4)", RFC 4361, February 2006. 9.2. Informative References [RFC2131] Droms, R., "Dynamic Host Configuration Protocol", RFC 2131, March 1997. [RFC4702] Stapp, M., Volz, B., and Y. Rekhter, "The Dynamic Host Configuration Protocol (DHCP) Client Fully Qualified Domain Name (FQDN) Option", RFC 4702, October 2006. [RFC4704] Volz, B., "The Dynamic Host Configuration Protocol for IPv6 (DHCPv6) Client Fully Qualified Domain Name (FQDN) Option", RFC 4704, October 2006. Halwasia, et al. Expires June 17, 2013 [Page 6] Internet-Draft DHCPv6 client link-layer address option December 2012 Authors' Addresses Gaurav Halwasia Cisco Systems Cessna Business Park, Sarjapura Marathalli Outer Ring Road Bangalore, KARNATAKA 560 087 India Phone: +91 80 4426 1321 Email: ghalwasi@cisco.com Shwetha Bhandari Cisco Systems Cessna Business Park, Sarjapura Marathalli Outer Ring Road Bangalore, KARNATAKA 560 087 India Phone: +91 80 4426 0474 Email: shwethab@cisco.com Wojciech Dec Cisco Systems Haarlerbergweg 13-19 1101 CH Amsterdam, Amsterdam 560 087 The Netherlands Email: wdec@cisco.com Halwasia, et al. Expires June 17, 2013 [Page 7]